The glazing mask F-4 E/G/S Phantom II in 1:72 scale from Dead Design takes the place of drawing the frame of the cabin out by hand with a brush, using a precisely cut self-adhesive film.
Responsibility details are not available.
A pre-cut self-adhesive masking set for the frame of the cabin. The parts are stuck onto the clear molding, cover the glazing and the frame is sprayed with an airbrush. Once the mask is taken off the boundary between the finish and the glass is sharp along its whole length.
The Phantom II in the F-4E, F-4G and F-4S versions belongs among the later forms of this two-seat twin-engine aircraft. The F-4E received a built-in cannon, the F-4G was intended for the suppression of ground air defenses and the F-4S arose by modernizing the naval version. The glazing of the tandem cabin is divided and on a model the frame is one of the most closely watched details.
The frame of a cabin can be drawn out by hand too, except that in 1:72 scale it is a few tenths of a millimeter wide on a model. Even a good brush wavers at such a width and the line comes out thicker in places and thinner in others; the eye notices it on glossy glazing immediately. A mask keeps a constant width along the whole length of the frame and the result is repeatable, which will be appreciated above all by anyone who builds several models of the same type. Consider also how much detail it makes sense to deal with inside: with a closed cabin in this scale almost nothing can be made out under the divided frame anyway, so it is more sensible to invest the time in a clean frame than in an interior that will not be seen.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!