A trapezoid melt head of 2.0 mm is an interchangeable tip with sloping sides that leaves an impression with a soft transition into the surface.
Responsibility details are not available.
Sloping sides change the character of the mark. While a right-angled cross section ends in a vertical wall, the trapezoid given in the name together with the value of 2.0 mm leaves a hollow in the plastic whose walls rise to the surface at an angle. The impression then does not look like a stamped plate but like a place where the material bent gradually, and paint later settles on it without a sharp break.
A tapered shape is pulled out of plastic more easily than a straight one, which suits deeper impressions where the tool risks drawing a melted thread behind it. Hold the tip perpendicular, otherwise one side comes out steep and the other flat. If a thin filament of melted material does appear, let it harden and only then break it off; when warm it only smears. If the hollow is to look older, dull its surroundings with a fine abrasive, a matte surface reflects light more softly.
Car modelers and builders of equipment who want to suggest a deformation of a panel, not a hole from a hit. The tip radiates heat even after being disconnected, so set it down on a metal or stone surface. Neither the material of the tip nor the device it belongs in is given in the name of the item and they cannot be derived from it.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!