Very fine mesh with a diamond pattern, 3D printed, in 1:35 scale, from RT-Diorama. The diamond pattern is the distinguishing feature against the hexagonal version of the same line.
Responsibility details are not available.
This is a 3D printed mesh in 1:35 scale, that is a material that you cut to the size you need. The pattern is diamond-shaped, and that is what sets it apart from the hexagonal version that the manufacturer makes alongside it. The advantage of printed mesh over real wire netting is that the mesh spacing matches the scale: a real mesh opening works out to just under two millimeters in 1:35, which real wire cannot reproduce. The manufacturer states that the material is very flexible, in its words almost like fabric. The length of the roll is not stated here.
Cut with sharp sheet metal scissors or a fresh scalpel blade on a mat; a dull tool will crush the openings. Trace the piece first and cut with a small allowance. Glue the mesh with cyanoacrylate glue in small drops, so the glue does not clog the openings. If you paint the piece, use very thin coats and preferably spray, because a thick brush coat floods the openings and the whole effect disappears. The mesh tolerates slight bending well, so it can be shaped around posts and over uneven terrain. The wire ends on fences look convincing when you leave them irregular and slightly bent.
For diorama builders in 1:35 scale who want mesh at the correct spacing, and for vehicle modelers who add fencing and grilles. It suits military and civilian scenes.
This is a material with sharp edges after cutting, not a toy. Keep it out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!