A polystyrene profile of rectangular section 1.0x2.0 mm and 35 cm long. Sold by the piece.
Responsibility details are not available.
A section of one by two millimeters gives the profile a clearly defined wider and narrower side. Stood on edge it acts as a slender beam, laid flat as a batten or a strap. One piece therefore covers two different roles depending on which side you turn outwards.
Most often it becomes the surrounds and trim of hatches, longitudinal stiffeners of a body, rail pads, window frames, floor battens, the lining of cargo areas and tread strips. On the wider side a flat riveted strap is imitated well, and on the narrower one it looks like a thin angle.
It is better to cut with light repeated passes of a knife than with one heavy one, because thin material compresses under pressure and the edge rounds off. The joint is made with polystyrene cement applied with a fine brush into a seam that has already been seated. Degrease the surface before painting, otherwise the film of paint will crawl where the fingerprints are.
One piece is 35 cm long. The material can be shaped a little after warming, but with a rectangular section watch that the profile does not twist about its own axis as it bends.
The rectangular section allows the profile to be laid flat or on its narrow edge and so to obtain two different looks from one material. Degrease the surface before gluing.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!