A thicker Evergreen plastic strip of 2.0x4.8 mm section, one piece 35 cm long.
Responsibility details are not available.
Two millimeters of thickness and just under five millimeters of width give this profile a stiffness that thin strips do not have. A piece like this carries its own weight even over a length of several centimeters, so a skeleton can be built from it onto which the thinner plating is only then glued.
In practice this produces chassis frames of trucks, beams under the roof of a warehouse, posts of a ramp, benches in a diorama or the inner ribbing of a large fuselage that is not visible from outside but keeps the model square. The heavier section also takes drilling, so a pin or a wire shank can be sunk into it.
With thicker material it is not a good idea to finish the knife cut in one stroke. Score a groove, draw the knife over it several times and snap the last bit, otherwise the edge rounds off and the joint will not seat afterwards. For right-angled joints it is practical to glue two parts up dry on a glass sheet, which guarantees that the structure stays straight.
Do not throw the offcuts away. They serve as spacers between a floor and a ceiling or as wedges that set the angle of a wall. Kept in a box sorted by length, they are found faster during the next build than it would take to unwrap a new piece.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!