Modeling screws with a hexagon head, 0.5 mm in size.
Responsibility details are not available.
A hexagon head is the most comprehensible shape of fastener there is: everyone knows it and on a model it works even when it is barely visible. The smallest sizes come into their own on small mounts, mirror holders, instruments and the clips of lines, that is where a more prominent head would overpower a surface rather than complete it.
These are screws with a hexagon head, in the 0.5 mm size. Half a millimeter really is very little, so count on them being worked differently from larger parts: without fine-tipped tweezers and good light the detail is more likely to be lost than fitted. But it is exactly these sizes that keep the right proportion on models in smaller scales.
Work over a pad with a raised rim, so that a part that springs away does not end up in the carpet. Pre-drill the hole with a bit matching the size and choose the depth so that the head seats on the surface rather than sinking into it. If the part has no thread, glue it into the hole. Apply the glue in a minute amount on the tip of a wire; with a part of this size an amount barely noticeable on the wire is enough.
They suit modelers who are finishing small assemblies and want an exposed joint on them too, in the right proportion to its surroundings.
The package holds the screws only. A model, glue and paints are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
