Pylons for the MiG-29 in 1:48 scale (Reskit) are a 3D printed accessory with APU-470 rails for R-27 missiles and APU-60 rails for R-60 missiles. It is not an aircraft model but weapons pylons.
Responsibility details are not available.
The set contains underwing pylons and launch rails for the MiG-29 fighter in 1:48 scale. Specifically it holds two APU-470 rails for medium-range R-27 missiles and two APU-60 rails for short-range infrared R-60 missiles. It is not an aircraft model but a precise accessory with which you replace coarser plastic parts and lay the stores out as the real subject carried them.
The MiG-29 is a Soviet and later Russian fourth-generation frontal fighter. The R-27 missiles served for combat at medium range, and the light R-60s were armament for close maneuvering combat. Faithful pylons and rails are the key to a realistic load, because it is by them that the correct configuration of an aircraft is recognized.
Wash the parts free of print residue, separate the supports carefully and bond them with cyanoacrylate (super glue). Apply a primer before finishing. Protect your airways when sanding prints.
The accessory is supplied unassembled and unpainted. Glue, paints, missiles and the model are not included, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
