The K-36D ejection seat in 1:72 scale is a 3D-printed resin accessory from Temp Models.
Responsibility details are not available.
A resin K-36D ejection seat in 1:72 scale from the Russian brand Temp Models. In a small scale the seat is the only piece of the cockpit that is really visible under the canopy, and the plastic version from a kit tends to be coarse and without belts. Printing in resin manages the shell, the rests and the harness in one part. It is not an aircraft kit but a replacement part for your own model.
K-36 is a family of Soviet and Russian ejection seats that belongs among the most successful designs of its kind. The seat can save a pilot even in a situation where the aircraft is flying very low or standing on the ground, and it became famous at air shows where an escape took place before the eyes of the spectators. The characteristic mark of the family is the telescopic stabilizing booms that extend once the machine has been left.
Release the seat from the supports with a new blade and level the surface underneath it. Wash the resin in lukewarm soapy water before painting. Spray the base shade, lift the edges with a dry brush and darken the recesses with a tone. Paint the belts in a different tone and suggest the buckles with a fine tip; they are what makes the greatest impression in a small scale.
The set is supplied unassembled and unpainted. The model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
