GT65H - a spare 1.00 mm blade for the Mr. Line Chisel GT-65 scriber from Gunze (Mr. Hobby). An extra wide blade for the handle you have to own; intended for very large models and coarse parting lines.
Responsibility details are not available.
This is a spare scriber blade, not a standalone tool. It is fitted into the Mr. Line Chisel GT-65 scriber (the handle) from the manufacturer Gunze (Mr. Hobby), which you have to have - without the handle you will not use the blade. The width of 1.00 mm is extra wide within the range: it is among the coarsest blades and on an ordinary model it would be too robust.
With a scriber you restore and deepen the molded parting and panel lines, which lose their depth and disappear after seams have been sanded and coats of clear have been applied. A re-engraved line stays legible and takes a wash nicely to bring the detail out. Engraving is done by pulling toward you, at a slight angle, in several light repeated strokes - you control the depth by the pressure.
For modelers with a special need for wide and deep lines on sizable builds. On an ordinary aircraft or car model in a small scale, 1.00 mm is needlessly coarse - for finer work reach for the narrower blades in the range (0.10 to 0.70 mm) or for the shallow blades.
The blade is very sharp - handle it carefully, engrave away from your fingers and use a template. Store out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
