Aber Engrave plate (88 x 57 mm) – pattern 10 is an etched brass plate that serves as a form for impressing a fine regular texture into thin foil.
Responsibility details are not available.
An etched brass plate from the Polish maker Aber with pattern number 10. It is used as a die: thin material is laid on the plate and the pattern is burnished into it. The working area measures 88 x 57 mm without the frame. The plate is a tool; what reaches the model is only the material you work on it.
A fine pattern calls for careful preparation. The material has to lie completely flat and free of creases, otherwise the texture is transferred unevenly. Use a burnisher with a smooth rounded end; a sharp edge would tear the pattern in the material. Small parts are easily lost, so cut them out of a larger piece only after the impression and leave a margin around them to hold on to. The texture shows up nicely once matte paint has been sprayed on and a dry brush passed lightly over it to bring out the raised edges.
For meticulous modelers who finish off the details of interiors and exteriors alike, and for workshops where a general-purpose tool with no tie to one particular kit comes in handy. A finer texture also comes into its own where a coarse relief would look unconvincing in the scale in question.
This is a modeling tool, not a kit. Material for transferring the pattern is not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
