The 0.20 mm needle for the Fine Art 180X airbrush is a spare part for a fine airbrush. It replaces a bent tip and gives the gun back its ability to draw a thin line.
Responsibility details are not available.
A spare needle 0.20 mm in diameter for the Fine Art 180X airbrush. Such a fine diameter is meant for detail work: thin lines, hairline streaks, soft transitions on figures and small markings. It is with needles like these that the slightest bend of the tip makes the gun stop doing the one thing you bought it for.
The finest diameters are used for detail shading, for drawing lines and for work in very small scales. They do call for well thinned paint and lower pressure, though; thick paint clogs a fine nozzle at once. For covering large areas such a diameter is unsuitable, because the spray is too narrow and the area is covered slowly and unevenly.
Loosen the rear chucking nut and pull the needle out backward, never forward through the nozzle. Push the new needle right home into the taper of the nozzle and only then tighten the nut. Never clean the tip with abrasive paper. After every session, flush the gun and wipe the needle with a cloth moistened in cleaner; dried paint on a fine needle is the most common cause of spitting.
This is a separate spare part, not a whole airbrush. The package does not contain a nozzle, a hose or paints.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
