The styrene strip 0.75 x 4.00 x 350 mm from AK interactive is a package of ten firm polystyrene strips for supports, platforms and load-bearing elements of your own parts.
Responsibility details are not available.
Ten pieces of plastic strip of rectangular section 0.75 x 4.00 mm and 350 mm long. The material is polystyrene, the plastic known from injection-molded kits — it is cut with a knife, glued with cement for models, sanded, filled and painted. It is not a model but a material for building your own parts and superstructures.
The combination of four millimeters of width with a stiff thickness makes this size a material for elements that have to carry something. A wide gluing face at the same time means a firm joint, so the strip suits places where two larger parts have to be joined reliably.
A thicker and wider strip is cut in several passes: score it about halfway and break the rest over the edge of a surface. Then level the cut on abrasive paper, as on a wide strip an end that is not square shows most. It is glued with a thin cement for polystyrene, which runs into the joint and melts the plastic; with a large gluing face apply it in portions, so that the cement does not run away outside the joint. For joints with resin, photo-etched metal or wire use cyanoacrylate glue. Before painting, sand the surface and cover it with a base coat.
It is a material for building, not a finished model. Glue, paints and tools are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
