The DSPIAE tungsten steel drill bit 1.6 mm is a single modeling drill bit for drilling into the plastic of kits. It is used where you want to replace a plastic detail with a metal tube or wire.
Responsibility details are not available.
This is one particular diameter, not a set and not a drill. You clamp the bit into a hand chuck or into a modeling micro drill and drill with it into the plastic of kits. The manufacturer is DSPIAE, and the material and the diameter are stated in the item name itself.
A diameter of 1.6 mm is the typical size for the moment when you want to swap a plastic part for metal. A hole of this size takes a thin brass tube or a heavier wire, so it suits fitting machine gun barrels, pitot tubes, antennas or exhausts. The second common use is drilling a hole for a pin with which you join two parts firmly instead of relying on a glued joint alone.
The procedure is always the same: first mark the center of the hole with a needle or the point of a scalpel, so that the bit does not slip on a rounded surface. Then drill perpendicular to the surface, slowly and without pressure. In plastic the bit feeds itself, and haste only leads to the part cracking or the hole running off center.
For the modeler who improves kits with metal details, and for anyone who buys diameters individually according to what they are building. Before buying, check that the range of your chuck will take the shank of the bit.
The point is sharp, so keep it out of the reach of children. Drill on a firm surface and do not inhale the fine plastic chips.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
