The DSPIAE Tungsten Steel Panel Line Scriber Push Broach 0.3 mm is a push scriber of tungsten steel with a chisel edge, intended for scribing and restoring panel lines on plastic models.
Responsibility details are not available.
A push broach scriber of tungsten steel with a flat, chisel edge 0.3 mm wide. It differs from a classic scribing needle in the principle of the work: a needle pushes the plastic aside with its point, whereas a chisel edge removes it with the whole edge. The result is a groove with a flat bottom and a constant width along its whole length, which behaves the same at the start of the stroke as at the end.
Scribing comes in only after rough assembly and sanding of the parting seams. It is precisely sanding a seam that reliably erases the panel lines around it, and if they were not restored, a dead band without detail would stay on the model once it is painted. A width of 0.3 mm is a sensible all-round choice for ordinary panel lines at this stage.
For the modeler who does not want to leave cleaned-up surfaces without detail, and for anyone who works with an eye on how the model looks once painted. It guides the stroke in one direction, so it also copes with work along curves and leading edges, where a needle would skid.
The edge is sharp and brittle under a side load. Guide the stroke away from your other hand, store the tool so that the tip does not touch other metal objects, and remove the chips with a brush, not by blowing.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!