QMT 1:32 Bf 109 G series – wheel bay masks is a set of self-adhesive masks for painting the wheel bays of the G-2 to G-14 versions in 1:32 scale.
Responsibility details are not available.
Die-cut self-adhesive masks for painting the wheel bays of Messerschmitt Bf 109 fighters in the G-2, G-4, G-6, G-10 and G-14 versions in 1:32 scale. This is an aid to painting, not a kit or spare parts: the mask separates the shade of the inside of the bay from the surrounding finish. The number of masks and the exact extent of the coverage are stated on the manufacturer's packaging.
Lifting the mask off is the moment when the work is either confirmed or ruined. Do not wait until the paint has over-dried and hardened into a brittle film, but do not lift it while it is damp either. The ideal state is a finish that is dry to the touch and has rested for a few hours. Take the mask by a corner with tweezers and pull it back over itself at an acute angle, not perpendicular upward; a perpendicular pull tears the paint at the edge. When the mask is stuck down firmly, warming it slightly with a hairdryer on a low setting helps. Any small seepage is repaired with a fine brush, but only spot by spot, never by running the brush along the whole edge.
Paint the inside of the bay before masking and let it cure. The G series takes in a wide spectrum of production batches that differed in their equipment and in details of the airframe, but that has no effect on painting the wheel bays. Do not reuse masks already lifted from the same sheet, because after the first removal the adhesive holds considerably worse.
The package contains masks only. The kit, the paints and the glue are not included in the delivery.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!