Young Miniatures 1:10 Royal Navy Captain 1806 is a resin portrait bust of a naval officer in 1:10 scale. It is supplied unpainted and the main work is painting the uniform and the face.
Responsibility details are not available.
A portrait bust in modeling resin in 1:10 scale from the Young Miniatures studio, with a naval officer as its subject. It is supplied unpainted and is not built like a model: putting the parts together is a matter of minutes, whereas preparing the surface and the painting take up most of the time. Busts in uniform are among the most rewarding painting tasks: they combine large areas of broadcloth, small metal and gilded elements and a face, on which a painter's level shows fastest of all. In sculptural terms this type rests on the contrast between a softly modeled face and the hard-cut edges of the collar and the lapels.
Wash the casting in lukewarm soapy water, because resin holds mold release agent from the mold and neither paint nor primer will stick to it. Cut the casting gates off with a sharp scalpel and finish the surfaces with wet sandpaper; protect your airways while sanding. Dry-fit the parts first so that you know where to fill. Fill the seam with modeling putty or with super glue and an accelerator, sand it back and restore the interrupted texture with a scriber. Finally apply a thin coat of primer, ideally gray, which shows up the remaining scratches and unifies the base.
Build the skin up from a mid-tone layer: glazes in the eye sockets, under the cheekbones and in the corners of the mouth, lightening on the forehead, the bridge of the nose and the chin. Oils let you blend the transitions soft, acrylics layer faster. Paint the eyes in an off-white, never a pure white, then the iris, the pupil and the line of the upper eyelid. Start the hair and any sideburns from a dark base and pick the strands out with a dry brush. Build the broadcloth of the uniform from a mid color, lighten the edges and seams and put a dark glaze into the folds, because without this modeling the area looks like plastic in 1:10. Do not paint the white and light parts in pure white but in a broken shade, or they will outshine the face. The lace and the buttons can be done with gold metallic paint over a smooth darker base or with the non-metallic metal technique. Finally unify the sheen: the uniform matte, the skin satin, the metal glossy. Pin and glue the finished bust to its base and display it under light from above and in front.
The bust is supplied unassembled and unpainted. Paints, glue and putty are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!