The masking set Eduard 1:24 Mosquito FB Mk.VI TFace holds masks for the outer and the inner side of the glazing. The cockpit frames of the large model therefore come out right from both sides.
Responsibility details are not available.
This is not a kit but a set of self-adhesive die-cut masks for a model of the Mosquito FB Mk.VI fighter-bomber in 1:24 scale. The TFace designation means that the package holds masks for the outer and for the inner side of the glazing. The cockpit frames can therefore be sprayed with the interior shade from within and with the covering color of the airframe from outside, exactly as it was on the real aircraft.
On a model in 1:24 scale the glazed area is large and the inside of the frames is clearly visible. If only the outside is masked, the frame stays transparent from within and the whole impression falls apart. The inner masks solve that, and their shapes follow the outer set exactly, so the paint edge sits on the same line from both sides.
Mask and spray the inner side first, let the paint dry and only then stick the outer masks on. Degrease the glazing beforehand. Lift the mask off the sheet with tweezers or the tip of a scalpel and press it down with a soft wooden tool so that the clear plastic does not get scratched. Apply the paint in several thin coats. Remove the masks shortly after drying, pulling sideways rather than straight up. Wipe off adhesive residue with a cotton swab moistened with alcohol, carefully and away from painted surfaces.
This is an accessory, not an aircraft model. The kit, paints and glue are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
