A narrow rectangular melt head of 1.3 mm serves as the interchangeable tip of a heated tool for fine shaping of plastic with heat.
Responsibility details are not available.
The narrowest work with heat starts with a narrow cross section. The name of this item gives a rectangular shape and a dimension of 1.3 mm, that is a tip for small interventions where a stronger profile would hit the surroundings too. The mark that arises is short and shallow, it can be laid side by side, and a row of small touches thus creates a broken line that one wide impression could never imitate.
A narrow tip holds less heat and therefore cools faster; instead of more pressure, rather wait for it to warm through. Support the part firmly, because with small components a slight jerk is enough and the mark ends up somewhere other than you intended. You will value working under a magnifier or with a good spot light the more, the smaller the model you are working on.
Builders of aircraft and equipment in small scales and everyone who wants to add a fine irregularity to a surface without losing the detail around it. The tip stays hot even after switching off, so set it aside from the bench with the parts and wait until it has cooled completely. Neither the material of the tip nor the way it is clamped is given in the name of the item, so compare them with your own tool beforehand.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!