A photo-etched detail set for the bomb bay of a Boeing B-17F Flying Fortress model in 1:48 scale.
Responsibility details are not available.
On the four-engined B-17F Flying Fortress bomber the bomb bay was a tall space in the middle of the fuselage, divided by a narrow catwalk along which the crew got from the front of the aircraft to the rear. The bomb racks stood on either side of the catwalk, and around them the fuselage framework with its stiffeners and piping stayed visible. With the bomb bay doors open, the whole space is exposed on a model.
Photo-etched parts in thin metal sheet for the bomb bay area in 1:48 scale. They replace simplified plastic shapes where a fine profile belongs, and add details that cannot be rendered in plastic. The enclosed manufacturer's instructions describe the exact range of parts and the assembly order; they also tell you which parts of the kit are thinned or cut away before the photo-etch is glued on.
Separate the parts from the fret with a sharp blade on a hard surface and sand the burrs away. Make the bends in a bender or between two blades. It is better to complete and paint the assembly outside the fuselage and only then glue it inside, because once the fuselage is closed the space is hard to reach. Degrease the metal before painting and spray it with a primer.
The set is meant for a modeler who wants the bomb bay open and does not mind working with small metal parts. You need tweezers, a sharp blade and cyanoacrylate glue. Check in the instructions which 1:48 kit the set is developed for. The kit, paints and glue are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!