Ten triple blocks 1 mm in size from 3D printing. The finest member of the line, intended for the running rigging of sailing ships in small scales.
Responsibility details are not available.
A block with three sheaves side by side was among the strongest elements of the running rigging. The line passed through it three times each way, so the crew could raise a lower yard or haul in a sheet that a plain number of men on a rope would not have managed. It therefore appeared on the halyards of yards, on the main sheets and on the assemblies by which boats were lowered and hoisted.
This size measures one millimeter and is the smallest member of the whole line. That is roughly how an ordinary ship's block comes out in scales around 1:350 to 1:200, that is where it practically cannot be made from a wooden blank. There are ten pieces in the bag.
The grooves of the sheaves and the rim of the shell come out of 3D printing more crisply than anything that can be turned at a similar size. The parts sit on a thin tree of print supports and are separated with a sharp scalpel; the mark left by the support is leveled by a fine file or sandpaper of around one thousand grit.
The set serves for building rigging and forms no whole in itself. Count on a finished sailing ship using up several dozen blocks, usually in two or three sizes at once.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!