1:72 10L water canister, USA / Canada supplies ten very tiny water containers in printed resin for 1:72 scale.
Responsibility details are not available.
In 1:72 scale a ten-liter container measures barely a few millimeters, yet it catches the eye on a model at once. The set brings ten of them, which is enough to occupy the holders of one vehicle and to distribute some around a setting. The printing manages even such a small volume with no loss of shape.
The plastic container for drinking water has accompanied North American equipment since the 1960s. It does not rust, does not pass a taste to the water and stands up to temperatures well below freezing and to summer heat alike. The smaller volume is used where a large supply is not needed or where there is no room, typically with reconnaissance and signals vehicles.
Work in this scale forgives little. Use tweezers with a fine tip, cut on a soft surface and put the finished pieces into a dish, not on an open table. Apply the primer only as a mist coat, because a heavy layer would flood the tiny relief. The tone of the water in the hollows is suggested by a wash noticeably darker than the main color, applied only into the corners and under the handles.
The parts arrive raw and tiny; the color finish and the placing stay with the modeler.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!