A set of the three finest diameters of the Allen cone head: 0.5, 0.6 and 0.7 mm. The lower part of the scale in one package.
Responsibility details are not available.
This package covers the lower third of the scale offered, that is 0.5, 0.6 and 0.7 mm. The differences between the neighboring steps are so small here that you will tell them by eye only when laying them side by side, and that is exactly why it makes sense to have them at once. During a build the size is not chosen in theory but by laying it on the particular place.
The finest step goes to the instrument panel, to switch covers and to the small clips of control cables. The middle one tends to be the choice for fuel taps and smaller brackets. The coarsest of the three will already manage the holders of mirrors or footpegs. In 1:12 scale the whole set falls into the range of six to eight and a half millimeters of real head width, that is roughly between M4 and M5 screws.
The set does not end by chance. At 0.7 mm the second package follows on, covering the remaining five coarser diameters, so the two together take in the complete scale with no step left out and no overlap. Anyone building a whole machine usually needs both.
We recommend working over a light-colored pad and with sharp tweezers, because elements of this size are very hard to find once they fall. Drill the holes slowly in a pin vise; fine bits break from twisting rather than from pressure.
In very small scales even 0.5 mm runs up against its limit. On an aircraft build in 1:72 scale such a head would match a real thirty-six millimeters, which is a size not found on the airframe of an aircraft. The lower end of the scale is thus built for large road machines, not for miniature scales.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!