A diameter of 1.2 mm, a flat head with a large seating face and a slot, the upper limit of the range commonly offered.
Responsibility details are not available.
1.2 mm closes the group the brand also sells as a common whole. Above this diameter the range carries on only in some lines, so this size tends in practice to be the largest one works with on a motorcycle model. On a real machine it matches the joints that carry force, not the screws of covers.
You have two options and each looks different. Setting it on the surface is faster and the head stands out by its whole height; sinking it into a shallow recess, by contrast, suppresses the profile and the joint looks as though it were part of the casting. Decide according to the real subject before you pick up the bit, because afterward it can no longer be changed.
You make a shallow recess by running a bit two tenths wider briefly into the drilled hole, turning it only in your fingers. A few turns are enough; powered tools melt the material here and the edge rises into a collar, which is then harder to sand than it would be worth.
Before putting the element in, check that the bottom of the recess is flat. A conical bottom tilts the head and in a view along the surface one side of the joint will stand off.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!