An ABS plastic strip of 0.50 x 4.00 mm in section and 350 mm long, ten pieces in the bag. A stiffer section for load-bearing and edge elements of your own building.
Responsibility details are not available.
This size is noticeably stiffer than the thinnest strips, and so it suits everywhere the element is to hold its shape by itself. It will serve well as an internal stiffener of a bulkhead, as the frame of a platform or of boarding, as the edging of a loading ramp or the edge of a diorama base. It also comes into its own where a surface is built up from individual planks and each of them needs a thickness that can be made out.
The strip is 0.50 mm thick, 4.00 mm wide and 350 mm long. There are ten pieces in the bag, that is 3.5 meters of material in all. Converted into 1:35 scale, the width of 4 mm corresponds to roughly 14 cm in reality and the thickness of 0.50 mm to just under two centimeters, which comes close to an ordinary thick plank. The material is ABS, a tough plastic that can be cut, sanded and drilled cleanly and has no tendency to crumble while it is worked.
For dividing it use a sharp blade and a ruler: draw several light cuts one after another and then snap the strip; at this thickness a saw with fine teeth helps as well. Level the edges with abrasive paper, so that the joint sits. ABS is not polystyrene, so a solvent cement for polystyrene kits need not take reliably; try it on an offcut, otherwise reach for cyanoacrylate glue. Before painting, wash the area and degrease it.
Ten pieces of strip section are supplied in one bag. Glue, paints and tools are not included, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!