Ten flat ABS strips with a cross section of 0.50 x 5.00 millimeters and a length of 350 millimeters, 3.5 meters of material in all for building your own parts.
Responsibility details are not available.
The bag holds ten flat ABS strips with a cross section of 0.50 x 5.00 millimeters and a length of 350 millimeters. That is 3.5 meters of material in all. This is not a finished part or a set for a particular kit but stock from which you make the shape you need yourself.
Five millimeters of width is the size in this line for surfaces, not for strips of trim. The material gives you planks for boarding and floors, cargo beds, edging, ramps, fences, stops for gluing or a replacement for a larger broken part. The half-millimeter thickness holds a flat plane and can still be bent slightly, so the strip also works on gently curved surfaces. In 1:35 scale a width of five millimeters corresponds to roughly seventeen and a half centimeters in reality, that is, a wide plank, and the thickness to just under two centimeters.
Divide the strip by scoring it several times with a sharp blade against a metal ruler and then snapping it; at this width it pays to run the cut in several light passes so that the edge does not wander. Then sand the cut with fine abrasive paper so that the end sits flat. It is bonded with super glue or with an adhesive intended for ABS. Try solvent polystyrene cement on an offcut first, as ABS reacts to it differently than ordinary modeling plastic. Before painting, wash and degrease the surface and apply a primer; paint holds far worse on the bare material.
Glue, paints and tools are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
