Young Miniatures 1:10 Ramses II BC 1279 is a resin portrait bust in 1:10 scale with an ancient Egyptian subject. It is supplied unpainted and the main work is the painting, not the building.
Responsibility details are not available.
A portrait bust in modeling resin in 1:10 scale from the Young Miniatures studio, an ancient Egyptian portrait subject. It is supplied unpainted and is not built like a model: putting the parts together is a matter of minutes, whereas preparing the surface and the painting take up most of the time. In sculptural terms it is a type with large clean surfaces and sharp edges. That is demanding to paint, because a large smooth surface will not forgive an uneven base, but in return it allows you to work with striking contrasts of matte skin, metallic sheen and saturated bands of color.
Wash the casting in lukewarm soapy water, because resin holds mold release agent from the mold and neither paint nor primer will stick to it. Cut the casting gates off with a sharp scalpel and finish the surfaces with wet sandpaper; protect your airways while sanding. Dry-fit the parts first so that you know where to fill. Fill the seam with modeling putty or with super glue and an accelerator, sand it back and restore the interrupted texture with a scriber. On this subject sanding back matters especially, because on large smooth surfaces every remnant of a seam is visible from a distance. Finally apply a thin coat of primer, ideally gray, which shows up the remaining scratches and unifies the base.
Build the skin up from a mid-tone layer: glazes in the eye sockets, under the cheekbones and in the corners of the mouth, lightening on the forehead, the bridge of the nose and the chin. Oils let you blend the transitions soft, acrylics layer faster. Paint the eyes in an off-white, never a pure white, then the iris, the pupil and the line of the upper eyelid. The gilded areas can be done with translucent metallic paint over a smooth and rather dark base; the pigment settles to the bottom, so stir the paint thoroughly before every use and apply it only at a later stage, because it is hard to overspray and to mask. The more elegant, if more laborious, route is non-metallic metal. Saturated bands of color call for an opaque base and clean edges, for which masking tape cut into narrow strips pays off. Put a dark glaze into the engraved lines to bring out the geometry. Pin and glue the finished bust to its base and display it under light from above and in front.
The bust is supplied unassembled and unpainted. Paints, glue and putty are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!