A 110 mm exhaust tip, type A, in 1:24 scale is a Hobby Design accessory for the rear of a car model; it replaces the original molded part of the exhaust.
Responsibility details are not available.
An accessory for builders of car models who want the rear taken as far as the front of a car. With it the end part of the exhaust tract is replaced, that is the part that on a real car tends to be polished and that reflects light on a model. The designation type A sets one form apart within the 110 mm size group, in which more versions are carried side by side.
A glossy tip lives off the smoothness of the base, so before painting go over the surface with fine abrasive paper or a polisher. If you want to leave the surface in a metal shade, reach for a metallic only in the last stage and apply it thinly, because the pigment clumps on a grainy base. Darken the mouth with a thin dark paint, so that the hole does not come across as flat, and wipe the transition to the outer edge off before it dries.
First remove the plastic shape and level the surface, so that the replacement seats with no gap. Then try the part dry and look at it from behind at the level of the bumper, because that is the way a model is looked at most often. When you are building a car with two tips, set them against each other by a single ruler; asymmetry at the rear is noticed sooner than any other inaccuracy.
The package holds an accessory for a build, not a model of a car.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!