Masking Tape (4) 40 mm is a masking tape from the manufacturer Master Tools, 40 mm wide. It is a modeling supply for masking before spraying, not a kit.
Responsibility details are not available.
This is a masking tape for modeling painting, specifically the wide variant from the numbered range of the manufacturer Master Tools. The number in brackets denotes the position of the set in this range, and the figure 40 mm is the width of the tape. The sister packages of the same range are made up of narrower widths; this is the widest one and serves above all for quickly covering large areas.
Apply the tape to a clean and dry surface and press the edge down along its whole length, so that no paint runs under it. If you need weaker adhesion on a delicate finish, stick the tape onto the back of your hand or onto glass first and only then onto the model. Spray in thin coats and from the edge toward the inside of the area, not perpendicular to the edge. Take the tape off shortly after the paint has dried, not after several days, and do it slowly and by pulling it back over itself at a shallow angle. With two-layer finishes, always check that the lower layer really has cured.
For everyone who sprays with an airbrush or with a spray can and needs sharp transitions and protection of finished surfaces. The wide variant suits above all large models of aircraft, equipment and cars, where covering an area with narrow tapes would take needlessly long.
It is a modeling supply, not a model. Paints and thinners are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!