A 110 mm exhaust tip, type B, in 1:24 scale from Hobby Design is a replacement for the end part of the exhaust for models of passenger cars.
Responsibility details are not available.
The rear of a car tends to be neglected on models, although it is exactly the part that faces the viewer in a display case. The exhaust tip is the most conspicuous element on it, and its molded form gives the scale away sooner than anything else. The accessory of the Hobby Design brand offers a separately made replacement in the form marked with the letter B within the 110 mm size group.
Measure the position from a fixed point on the model, for example from the edge of the bumper or from the edge of the diffuser, and note the distance on both sides of the car. Level the area left after the original part is removed and take the remains of plastic off, otherwise the tip will seat crooked. Before gluing, stand the model on a board and look at it from behind at a distance, where the eye notices a deviation more reliably than when looking from close up.
Around a tip a fine patina comes into play well, because even a carefully kept car has traces of soot behind the exhaust. Work with a very thin application of a dark shade and run the transition from the mouth outward, so that the patch has no sharp edge. If it is a car with a pair of exhausts, create the same effect on both sides, only with a slight deviation, so that the result does not look like a stencil.
The item is an accessory for a build; a model of a car is sold separately.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!