Ten double blocks 4 mm in size, made by 3D printing, for the rigging of sailing ship models.
Responsibility details are not available.
Ten double blocks 4 mm in size. Blocks belong to the basic equipment of the rigging of sailing ship models; in the double version they are used where two lines pass side by side or where the pull needs to be doubled at one point. Ten pieces in the package cover one complete section of rigging.
The parts are made by 3D printing, so remnants of the print supports are left on them. Cut them off with a sharp blade a little away from the part and carefully sand the rest down with fine sandpaper, so that the outline of the block stays clean. Wash and degrease the parts before painting, otherwise the paint holds badly. They are glued with cyanoacrylate glue; glue for plastic models has no effect on them.
Paint the blocks and let them dry thoroughly before you hang them and run the line through them; on finished rigging they are hard to paint and the brush easily catches on the surrounding lines. Pin the small parts onto double-sided tape while you work, otherwise one clumsy move means searching on the floor.
The set is intended for builders of sailing ships who want their rigging in uniform quality and size. It also suits topping up a stock when they run out on a model under construction. Unless stated otherwise, the paints, glue and lines are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!