Triple blocks 2 mm in size, printed by 3D technology, ten pieces in the package. An accessory for the rigging of historical ships.
Responsibility details are not available.
A triple block on its own does nothing. It multiplies the force only in combination with a second block that the line wraps around. An assembly made up of a triple and a double gave a wooden ship a hoist whose theoretical advantage ran around five or six. Such assemblies hung at the windlass, at the halyards of the big sails and everywhere the heaviest load was at stake.
The dimension of two millimeters suits models in scales of roughly 1:200 to 1:150. There the block is already clearly visible on the deck, but it is still hard to make by hand. The set holds ten identical pieces, so they are enough for a whole group of tie-off points on one side of the hull.
Rinse the printed pieces first and let them dry; only then separate them from the support tree. A dry part cuts more cleanly and there is no risk of the edge of the shell flaking off. Run the line through only once the paint has dried, otherwise the thread catches in the fresh finish and the block seizes up.
This is a separate accessory for rigging, not a part of any kit. Anyone building a ship from a historical plan will find the number of sheaves at each tie-off point in it, so the quantity needed can be worked out before ordering.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!