A multipurpose modeling vise. It clamps a small part while drilling, filing or bending and frees both of the modeler's hands.
Responsibility details are not available.
A multipurpose clamp aims at the jobs in which a modeler has to have both hands free: drilling holes into small castings, filing an edge down, bending wire or holding an assembly until the glue has set. A clamped piece does not move and the force goes exactly where you lead it.
Most of the damage done while finishing parts arises not from a bad tool but from holding a small piece between the fingers. The drill bites, the part spins round and cracks at its thinnest place. Firm holding moreover makes the angle of work more accurate: both a file and a drill follow the same path throughout, so an edge stays straight and a hole perpendicular. That is felt mainly on barrels, hinges and small equipment, where a deviation of one degree is noticed on a finished model.
Clamp resin and thin plastic with feeling and rather through a soft insert, for instance a strip of balsa or folded paper. Hard jaws can press a mark into a soft material which you then have to sand over. Before drilling, check that the part seats over its whole face and does not spring, otherwise the hole will wander to one side. After work, wipe the dust off the guide surfaces, so that filings do not get into the thread.
A clamp of this kind pays to be stored dry and slightly open; jaws drawn together with the remains of filings in the thread start to seize in time and the accuracy of the seating drops.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!