The DSPIAE Hook Broach 0.8 mm hook scriber creates a more pronounced line that survives primer and paint and that a panel wash catches in well.
Responsibility details are not available.
A pull scriber of tungsten steel with a working width of 0.8 mm. Within the range it is the coarser end of the spectrum of fine tips, so a scribed line stays legible even after several coats have been laid on.
Scribing is not the final step, it is preparation. After scribing, the surface has to be cleared of burr and dusted off, otherwise the dirt gets sealed in by the primer and brought out. The primer then always narrows the groove a little, and so does the next coat of paint, which is exactly why a wider tip is chosen on larger models. Next comes a panel wash or thinned oil paint, which runs into the groove by capillary action and creates a shadow; this is where it shows whether the line is of the same depth along its whole length. An unevenly scribed line is only recognized at this stage, when it is hard to repair, so it pays to check the depth against the light as you go.
It suits large scales, vehicles and robot models, that is everywhere a line should stay reliably legible even after a complete paint system.
A sharp tool, so protect both the tip and yourself. Keep out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!