Ten double blocks 8 mm in size, made by 3D printing. An accessory for the rigging of sailing ship and ship models.
Responsibility details are not available.
A block on a ship is the place where a line changes direction or where the pull is divided. A double block has two sheaves side by side, so two lines pass through it or one line passes twice, and it is used where more force or a clear run of the rigging is needed. On a model of a sailing ship there are most blocks on the masts and along the sides of the deck, and it is precisely their number and uniformity that decide whether the rigging looks orderly or like a tangle of threads.
Ten double blocks 8 mm in size. According to the name the parts are made by 3D printing, so they have the same shape piece by piece, which tells in rigging: the eye levels up repeating elements on a model at once. The 8 mm size suits larger models or more prominent places in the rigging, where a block is seen close up.
Printed parts carry remnants of the print supports. Cut them off with a sharp blade a little away from the part and then sand the mark down with fine sandpaper, so that the outline of the block is preserved. If the hole for the line is blocked with a remnant of material, clear it carefully with a micro drill bit. Wash and degrease the parts before painting, otherwise the paint holds badly on the smooth surface. They are glued with cyanoacrylate glue, not with glue for polystyrene. A wooden shade looks more faithful if you apply a darker glaze over the base and go over the edges with a lighter tone.
Ten blocks are supplied. The lines, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!