A bench vise for a modeling workshop, 120 mm tall, 60 mm wide, with a jaw opening of up to 40 mm.
Responsibility details are not available.
Drilling into a small casting is one of those activities during which people most often hurt themselves or break the part. Fingers holding a component are always in the drill's way, and the pressure you have to put on it rises at exactly the moment when there is least room for correction. A vise removes that problem by holding the part for you, leaving both hands free for the tool.
This piece measures 120 mm in height and 60 mm in width, and its jaws open to 40 mm. That is a size into which the fuselage of a fighter in a smaller scale, a tank turret, a block of resin casting or a longer metal barrel fits comfortably.
Put a soft pad in the jaws, a strip of rubber or heavy paper for instance, so that the serrations do not print into the plastic. On thin-walled castings, tighten sensitively, because the force a vise exerts without effort is far too great for a model.
When choosing between a larger and a smaller version, do not decide by the biggest part that comes to mind but by what you will be clamping most often. Most modeling work happens on parts smaller than two centimeters, and there wider jaws bring nothing extra. A forty millimeter opening does pay off, however, the moment you take on a whole fuselage or a ship hull, because a smaller one will no longer reach.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
