The DSPIAE Push Broach 2.6 mm push scriber is a tungsten steel tool for scribing coarser grooves and seams into plastic, where fine scribers are not enough.
Responsibility details are not available.
A scriber with a working width of 2.6 mm. The tungsten steel tip works by pressure: repeated light cuts remove material and create a groove of a given width instead of merely nicking the surface. It is not a tool for fine panel lines but for pronounced seams, dividing gaps and furrows that are meant to show on the model even once painted.
A width of 2.6 mm corresponds to structural detail rather than to fine panel lines. It is used for suggesting seams between large covers, for deepening the gap between fuselage sections, for a groove to seat a plastic profile in or for starting a notch that is then finished with a saw. On large scales and robot models a coarser groove is chosen deliberately, so that once painted it creates a deep shadow and breaks up a uniform surface.
It is reached for by modelers who already work with scribing and need to add a coarser width to a set of fine tips. It will not serve a beginner as a first scriber, because thin part walls are easily damaged with it.
The tip is sharp and can break off if levered sideways. Store it apart from other tools and keep it away from children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!