A double block with a hook 7 mm long, ten pieces in one package. 3D printed for the rigging of ship models.
Responsibility details are not available.
Joining two sheaves and a hook gave the crew an assembly that could be moved elsewhere in a moment. It was hooked into an eye, the line was run through the opposing block and a tackle with a threefold mechanical advantage was created. It was used for hauling down sheets, for tensioning halyards and for letting two men lift a load that would otherwise have needed six.
Seven millimeters is the stated length of the whole part including the hook. The set contains ten pieces and finds its use on sailing ships in larger scales, where distinguishing the number of sheaves makes any sense at all.
The double version is noticeably wider at the same length, because it has to take two sheaves side by side. On a model that difference is easier to see than the number of sheave grooves, which tends to be illegible at small dimensions. When you are building a historical ship from a plan, go by the width of the shell, not by the number of holes.
In the package you will find the blocks only, not the line or the eyes to hang them from. When planning, bear in mind that a tackle always needs two parts, so ten pieces from one bag cover five complete assemblies. The remaining pieces come in useful as a reserve, should one of them get damaged during the work.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!